Cisco Cisco D9804 Multiple Transport Receiver インストールガイド
Chapter 1 Quick Setup - Read Me First!
8
78-4042990-01 Rev B
Steps using the Web Interface
Logging on to the Web Interface
Proceed as follows to log on to the Web Interface:
1 Open MS Internet Explorer.
1 Open MS Internet Explorer.
Note: The D9804 MTR version 1.x is compatible with Microsoft Internet Explorer
6. The D9804 MTR version 2.x is compatible with Microsoft Internet Explorer 8
and Mozilla Firefox 3.6.
6. The D9804 MTR version 2.x is compatible with Microsoft Internet Explorer 8
and Mozilla Firefox 3.6.
2 Type the IP address of the D9804 MTR in the address bar and press Enter.
3 Type the Username and Password.
3 Type the Username and Password.
Note: The username and password are case-sensitive. The default username is
user and the default password is USER. If you have forgotten your username
and password you can reset them from the front panel menu of the D9804 MTR.
Important: The password and user name will be remembered for the whole of
the web session. Close the web browser if you want to prevent others from
accessing the settings of the D9804 MTR.
If your session expires, you must refresh the browser and log back in.
user and the default password is USER. If you have forgotten your username
and password you can reset them from the front panel menu of the D9804 MTR.
Important: The password and user name will be remembered for the whole of
the web session. Close the web browser if you want to prevent others from
accessing the settings of the D9804 MTR.
If your session expires, you must refresh the browser and log back in.
4 Click Login.
Click Reset to clear the Username and Password fields and re-enter the login
information.
information.
Setting Up the IP Parameters
Follow the procedure below when a D9804 MTR is added to or reinserted in the
installation.
installation.
Proceed as follows to set the IP parameters of the Ethernet port of the D9804 MTR:
1 From the user interface of the D9804 MTR, click the System tab and then
1 From the user interface of the D9804 MTR, click the System tab and then
Ethernet icon from the sub-page.
2 Enter the IP Address, Mask, and Gateway information.
3 Click Apply.
3 Click Apply.
Note: Changing the IP address, Mask and/or Gateway information may cause
your web browser to be disconnected from the MTR. Reconnect the web browser
and login again if necessary.
your web browser to be disconnected from the MTR. Reconnect the web browser
and login again if necessary.
Setting Up RF Tuning Parameters
Proceed as follows to set the RF input parameters:
1 From the user interface of the D9804 MTR, click the Setup tab, and click the RF-1
1 From the user interface of the D9804 MTR, click the Setup tab, and click the RF-1
to RF-4 for each of the inputs.