Cisco Cisco Digital Service Access Node (DSAN) 8210 インストールガイド
Step 3: Configure Hardware
78-4041038-01 Rev B
11
Step 3: Configure Hardware
Configuring the DSAN hardware involves four main activities:
Performing a basic power check
Checking and adjusting input signal levels
Checking and adjusting output signal levels
Checking and adjusting DSAN embedded cable modem (eCM) signal levels
Hardware configuration is performed with the DSAN housing open. Before you
begin, refer to To Open the Housing (on page 42).
begin, refer to To Open the Housing (on page 42).
When configuring the DSAN hardware, refer to the following block diagram for
help with component and port locations.
help with component and port locations.