Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split インストールガイド

 

 

Complete the following steps to attach the fiber connectors. 
1  Route the fiber pigtails through the rectangular slot at the right side of the fiber 

tray near the hinge. 

2  Carefully route the pigtails through the fiber tray channels one at a time so that 

each fiber pigtail connector lines up with its corresponding connector in the fiber 

tray. 
Important: Do not attach the connectors until they have been cleaned. See step 4 

below. 
Note: 

 

Route the fiber pigtails clockwise and as close to the outside edge of the tray 

as possible. 

 

Be careful not to use a tight fiber radius. The radius should be at least 1.5 in. 

(3.8 cm). 

 

The fiber tray has three unstowed locking positions at 70, 90, and 110 degrees. 

Change positions as needed while working. 

3  Adjust the fiber positions as needed. The pigtails must be adjacent to the 

connectors. 

4  Clean the tips of the fiber connectors. Refer to 

Cleaning Optical Connectors (on 

page 78).   

5  Attach the fiber connectors as shown in the following illustration. 

 

OL-29644-03 

23