Cisco GainMaker Opto Node 1GHz with 40 52 MHz Split and RF Redundancy インストールガイド
GainMaker Node
HMS Status Monitor Transponder
Installation Instructions
HMS Status Monitor Transponder
Installation Instructions
Overview
Introduction
The GainMaker® Node Hybrid Management Sublayer (HMS) Transponder (part
number 4006432) is designed to be installed in the lid of the GainMaker Node
housing. The HMS Transponder complies with the Society of Cable
Telecommunications Engineers (SCTE) HMS standard, which allows an element
management system (EMS) to monitor the components in a cable network.
The transponder can be configured after it is installed in a powered node, either
The transponder can be configured after it is installed in a powered node, either
on a test bench or on site. The transponder must be configured before it can be
activated in the EMS.
Purpose
These installation instructions will enable cable system operators or installers to
properly install and configure a GainMaker Node HMS Transponder in a
GainMaker Node.
Audience
This document is intended for authorized service personnel who have experience
working with similar equipment. The service personnel should have appropriate
background and knowledge to complete the procedures described in this
document.
Qualified Personnel
Only appropriately qualified and skilled service personnel should attempt to
install, operate, maintain, and service this product.
WARNING:
Allow only qualified and skilled personnel to install, operate, maintain, and
Allow only qualified and skilled personnel to install, operate, maintain, and
service this product. Otherwise, personal injury or equipment damage may
occur.