Cisco Cisco Digital Service Access Node (DSAN) 8200 インストールガイド
Chapter 8 Software Upgrade
212
OL-29943-01
Type: INTEGER
Permission: Read-only
Status: Current
MIB: DOCS-CABLE-DEVICE-MIB
Permission: Read-only
Status: Current
MIB: DOCS-CABLE-DEVICE-MIB
2 Verify that the new image is running in the DSAN.
Use the docsDevSwCurrentVers object to identify the software image version
number (e.g., 1.1.45).
Note: The docsDevSwCurrentVers object has the following attributes.
OID: 1.3.6.1.2.1.69.1.3.5
Type: SnmpAdminString
Permission: Read-only
Status: Current
MIB: DOCS-CABLE-DEVICE-MIB
number (e.g., 1.1.45).
Note: The docsDevSwCurrentVers object has the following attributes.
OID: 1.3.6.1.2.1.69.1.3.5
Type: SnmpAdminString
Permission: Read-only
Status: Current
MIB: DOCS-CABLE-DEVICE-MIB
3 Perform additional monitoring via CLI as needed.
To perform additional monitoring of the download and upgrade, open a CLI
session and observe CLI diag page 12.0. This page displays the current download
status, and while a download is in progress, also displays the byte count.
session and observe CLI diag page 12.0. This page displays the current download
status, and while a download is in progress, also displays the byte count.
Note: Software download may take several minutes to complete, and is followed
by an automatic DSAN reboot, which may take another several minutes.
After the download has completed, the DSAN has rebooted, and the upgrade has
successfully completed, the following status will be displayed on CLI diag page
12.0.