Cisco Cisco Digital Service Access Node (DSAN) 8200 インストールガイド
Installing and Removing the Power Supply Module
OL-29943-01
55
To Remove the Power Supply Module
Complete the following steps to remove the power supply module.
1 Open the node housing. Refer to To Open the Housing (on page 36).
2 Detach the power cable connector plug from the connector labeled POWER 1.
3 Using a screwdriver, loosen the two module retaining screws on the power
1 Open the node housing. Refer to To Open the Housing (on page 36).
2 Detach the power cable connector plug from the connector labeled POWER 1.
3 Using a screwdriver, loosen the two module retaining screws on the power
supply.
4
Carefully lift the module out of its well in the DSAN housing.
5 Close the housing. Refer to To Close the Housing (on page 36).