Cisco Headend System Release 2.7 インストールガイド

 

78-4021167-01 Rev D 

55 

 

21  Type lustatus and then press Enter. The system displays the status of the 

LiveUpgrade boot environment. 
Example:  You should see results similar to this example: 

 
Notes: 

 

The version of LIONN software associated with the f12.0.0.7p7 designation 

refers to the version of the SAIlionn package currently installed on the RNCS 

server. 

 

The version of LIONN software associated with the upgrade 

(LIONN_3.1.0.x) is the same as what is listed on the LIONN DVD. 

 

This example shows that the new version of RNCS software is not yet active. 

22  Type luactivate  LIONN_<version number> and then press Enter. 

Note:  <version number> refers to the version of the RNCS DVD. 
Result:  The system activates the new version of RNCS software and displays the 

following message: 

************************************************************************* 

The target boot environment has been activated. It will be used when you 
reboot.  
NOTE: You must use either init or shutdown when you reboot.  If you do 
not use one of these commands,  

the system will not boot using the target BE.          

************************************************************************* 

In case of a failure while booting to the target BE, the following 
process 

needs to be followed to fallback to the currently working boot 
environment: 

1. Enter the PROM monitor (ok prompt). 

2. Change the boot device back to the original boot environment by 
typing: 

   setenv boot-device disk:a 

3. Boot to the original boot environment by typing:      
   boot 

************************************************************************* 

Activation of boot environment <LIONN_3.1.0.x> successful.