Cisco Headend System Release 2.5 インストールガイド
Chapter 1 Initial Installation of RNCS Software
4
78-4021167-01 Rev D
5 Type console -f and then press Enter. A message appears that instructs you to
type #. to return to the ALOM port.
6 Press Enter again.
Results:
Control transfers to the console of the RNCS server (rather than the ALOM
port).
The ok prompt should appear.
7 After completing step 6, did the ok prompt appear, as described?
If yes, go to step 8.
If no, repeat steps 4 through 6.
8 Type #. (the # key followed by a period).
Results:
Control returns to the ALOM port.
The sc> prompt appears.
9 At the sc> prompt, type setsc if_network true and press Enter.
Result: One of the following results occurs:
If you have never before set the admin password for this server, the system
responds with a message similar to the following:
Warning: the setsc command is being ignored because the password for
admin has not been set.
Setting password for admin.
New password:
If the system detects that the admin password for this server has previously
been set, then the network management port of the server becomes
functional.
10 Did the system display the “setting password” message described in the first
bullet of step 9?
If yes, go to step 11.
If no, go to step 12.
11 Complete the following steps if the “setting password” message, described in the
first bullet of step 9, appeared after completing step 9.
a Type the new admin password and press Enter. The Re-enter new password
a Type the new admin password and press Enter. The Re-enter new password
prompt appears.
b Retype the new admin password and press Enter.
12 Type setsc netsc_dhcp false and press Enter. This command prevents the
Dynamic Host Configuration Protocol (DHCP) from obtaining the network
configuration.