Cisco Headend System Release 2.7 インストールガイド
Add and Configure the RNCS
4022447 Rev B
55
Creating BFS Source Definitions
Complete these steps to create the BFS source definitions for the RNCS.
1 On the DNCS Administrative Console, click the DNCS tab.
2 Click the System Provisioning tab.
3 Click Source. The Source List window opens.
4 Select the first source in the list and click File > Source Definitions. The Source
1 On the DNCS Administrative Console, click the DNCS tab.
2 Click the System Provisioning tab.
3 Click Source. The Source List window opens.
4 Select the first source in the list and click File > Source Definitions. The Source
Definition List window opens.
5 Click File > New Digital. The Set Up Digital Source Definition window opens.
6 In the first part of the Session ID, type the RNCS MAC address.
7 In the second part of the Session ID, type the original Source ID.
8 Click Next.
9 Click Save. The new source definition is displayed in the Source Definition List
6 In the first part of the Session ID, type the RNCS MAC address.
7 In the second part of the Session ID, type the original Source ID.
8 Click Next.
9 Click Save. The new source definition is displayed in the Source Definition List
as Pending.
10 Repeat this procedure from step 4 for each BFS source in the Source List.
11 When you are finished with this procedure, close the Source Definition List
11 When you are finished with this procedure, close the Source Definition List
window and the Source List window.
Starting the RNCS Sources
1 On the DNCS Administration Console, select the Application Interface Modules
1 On the DNCS Administration Console, select the Application Interface Modules
tab.
2 Click BFS Admin. The BFS Admin Sites window opens.
3 Select the RNCS you want to work with from the list, and click File > Select. The
3 Select the RNCS you want to work with from the list, and click File > Select. The
Site [site ID] BFS Administration window opens.
4 Click the Sources tab. A list of all the sources automatically created by the RNCS
installation process opens.
5 Select the first source in the list and click File > Open. The Set Up BFS Source
window for that source opens.
6 Select the DataPump: Run option.
7 Click Save. The Set UP BFS Source window closes.
8 Repeat steps 5 through 7 for each source in the RNCS with a Source ID less than
7 Click Save. The Set UP BFS Source window closes.
8 Repeat steps 5 through 7 for each source in the RNCS with a Source ID less than
or equal to 200.