Cisco Headend System Release 2.7 インストールガイド
Upgrade the RNCS Software
4022447 Rev B
61
Upgrade the RNCS Software
Upgrade the server with RNCS software using Solaris’ Live Upgrade. Live Upgrade
is a Solaris facility that allows operating system or application upgrades in an
inactive boot environment while the active boot environment continues to run
without interruption. Therefore, do not shut down the DNCS, RNCS, or Application
Server processes unless you are instructed to do so.
is a Solaris facility that allows operating system or application upgrades in an
inactive boot environment while the active boot environment continues to run
without interruption. Therefore, do not shut down the DNCS, RNCS, or Application
Server processes unless you are instructed to do so.
Important: If you are installing RNCS software on a Sun Fire server for the first time,
go to Initial Installation of RNCS Software.
go to Initial Installation of RNCS Software.
Upgrading the RNCS Software
Complete the following steps to upgrade the RNCS software.
1 Complete the following steps to remotely log on to the ALOM port of the RNCS
1 Complete the following steps to remotely log on to the ALOM port of the RNCS
server.
a From the DNCS, type telnet [IP address of ALOM port] and press Enter. A
a From the DNCS, type telnet [IP address of ALOM port] and press Enter. A
prompt for the user ID appears.
Note: Substitute the IP address of the ALOM port for [IP address of ALOM
port]. Do not type the brackets [ ] in the command.
port]. Do not type the brackets [ ] in the command.
b Type the admin user ID and press Enter. A prompt for the password appears.
c Type the password for the admin user and press Enter. The SC > prompt
c Type the password for the admin user and press Enter. The SC > prompt
appears as the system establishes a telnet session between the DNCS and the
ALOM port.
ALOM port.
2 Type console -f and press Enter. The following message appears:
Warning: Usr <> currently has write permissions to this console and forcibly
removing them will terminate any current write actions and all work will be
lost. Would you like to continue?
removing them will terminate any current write actions and all work will be
lost. Would you like to continue?