Cisco Headend System Release 3.2 メンテナンスマニュアル
Chapter 1 Staging Preparation
34
4024836 Rev D
4 Click the DHCT Groups tab. The DHCT Groups tab opens.
5 Double-click the group you want to which you want to add SSC DHCTs. The Set
Up DHCT Group window for the group opens.
6 Type the DHCT MAC address of a DHCT that you want to include in the new
group.
7 Click Add. The MAC Address of the DHCT moves to the Associated DHCTs
column.
8 Repeat steps 6 and 7 for each DHCT you want to add to the group.
9 When you are finished adding SSC DHCTs to the group, click Save.
9 When you are finished adding SSC DHCTs to the group, click Save.
Notes:
The DHCT should be connected to the network within 2 hours of creating or
adding it to a test group. If the device is not connected within 2 hours, then
the device does not receive a group assignment until the DNCS database
cycles through all in-service devices at a rate of approximately one device per
second. Depending on the number of devices in your system, this process
could take a significant amount of time.
If the device has an Administrative State of Out of Service, the CVT Group ID
message will not be sent by the PassThru process to that device. To check the
Administrative State of the device, see DHCT and CableCARD Module
Administrative Status (on page 38).
10 Confirm that the DHCT was successfully placed into the test group by
displaying the DHCT diagnostic screens and looking at the Group ID field. This
group ID should match the Group ID field displayed on the Set Up a DHCT
Group window on the DNCS.