Cisco Cisco DOCSIS EuroDOCSIS Transponder for GainMaker Nodes インストールガイド
Chapter 3 Operation
Preparation
Before You Begin
Before you begin, it is important to review and understand the following
information.
CAUTION:
Make sure the device is connected to a working CMTS and receiving
Make sure the device is connected to a working CMTS and receiving
proper input signals before you configure the transponder.
CAUTION:
For SNMP access, UDP ports 161 and 162 must not be blocked.
For SNMP access, UDP ports 161 and 162 must not be blocked.
To Configure CMTS for the Transponder
Before you begin, make sure you have downloaded the Euro-DOCSIS/DOCSIS root
certificate and configured your CMTS successfully.
Refer to the Downloading the DOCSIS Root Certificate to the CMTS section in the
Refer to the Downloading the DOCSIS Root Certificate to the CMTS section in the
document DOCSIS 1.1 for the Cisco CMTS of the profile Cisco CMTS Feature Guide
to configure your CMTS before installing the transponder in the CMTS network. The
above document is applicable for both Euro-DOCSIS and DOCSIS root certificates.
The document is stored in the following address on Cisco.com:
The document is stored in the following address on Cisco.com:
20
OL-31165-02