Cisco Model 6385 BTSC Stereo Encoder (NTSC) インストールガイド
Adding and Deleting Service Groups to a USRM Using the Web Interface
4039132 Rev B
317
Adding and Deleting Service Groups to a USRM
Using the Web Interface
Using the Web Interface
Adding Service Groups to a USRM
Adding a service group and other resources to a USRM in release 1.5.0 or greater
requires a process that is a combination of procedures on the USRM as well as on the
DNCS. The basic flow of the process is as follows.
1 From the DNCS, create the service group and assign it to the USRM.
2 From the USRM, create/add/modify resources and associate service groups to
requires a process that is a combination of procedures on the USRM as well as on the
DNCS. The basic flow of the process is as follows.
1 From the DNCS, create the service group and assign it to the USRM.
2 From the USRM, create/add/modify resources and associate service groups to
the QAM output ports.
3 From the USRM, associate zone information with the service groups for sites
configured with zones.
Note: You should open a tail of the USRM's EventLog to monitor the actions that
occur during the process.
occur during the process.
The following sections explain each of these procedures in detail.
Creating/Modifying a SDV-Enabled Service Group on the DNCS
Perform the following steps to create or modify a SDV-enabled service group on the
DNCS.
1 Access the Service Group Data - Open Service Group screen.
DNCS.
1 Access the Service Group Data - Open Service Group screen.