Cisco Model 6109 6 MHz Off-Air Reference (NTSC) インストールガイド
Chapter 3 USRM Web Interface
136
78-4021139-01 Rev D
ResourceManager - Network Config Page
In certain network configurations, it is required or at least desirable that the primary
and standby servers use the same service IP address. The USRM supports this
requirement through the use of virtual interfaces.
Configuring a service address on the ResourceManager.Network Config page and
Configuring a service address on the ResourceManager.Network Config page and
resetting the USRM software will cause the software to create a virtual interface that
it will use as the service address. This setting will then be synchronized to the
standby server for use in case of a failover event. When a virtual interface is in use, it
will be displayed on the Virtual Interfaces page.
The following illustration shows the ResourceManager - Network Config page.
The following illustration shows the ResourceManager - Network Config page.
Parameters
The following table explains the ResourceManager - Network Config page
The following table explains the ResourceManager - Network Config page
parameters.
Parameter
Description
ServiceAddress
The IP address of the resource manager virtual interface.
The software must be restarted after changing this value.
Note: This service address must be valid and available in
Note: This service address must be valid and available in
the address space.
ServiceInterface
The interface used for the virtual interface. The software
must be restarted after changing this value.
ControlAddress
The IP address of the resource manager virtual interface
for interacting with the resources. The software must be
restarted after changing this value.
ControlInterface
The interface used for the virtual interface used for
interacting with the resources. The software must be
restarted after changing this value.