Cisco Model 6109 6 MHz Off-Air Reference (NTSC) インストールガイド
Perform Initial Server Setup
78-4021139-01 Rev D
449
Perform Initial Server Setup
Complete the following steps to set up and configure the USRM.
1 Type the following command at the system prompt, and then press Enter:
1 Type the following command at the system prompt, and then press Enter:
cd /opt/usrm
Note: Be sure to include the space following cd in the command.
2 Type the following command at the system prompt, and then press Enter:
./setupusrm.sh
The setup script prints out your MAC address for reference, and then prompts
you with a series of questions about your particular setup environment.
3 Answer the following on-screen questions to set up the network and USRM for
your particular environment.
Note: If you make an incorrect entry, press <CTRL> C and start over.
Note: If you make an incorrect entry, press <CTRL> C and start over.
Do you wish to enable eth0? (yes/no)
Answer yes if you want to enable the first Ethernet device. If you answer yes
to this question, you are prompted with the following question.
–
–
Acquire eth0 info via DHCP? (yes/no)
Answer yes if you have a DHCP server you would like the machine to get
its IP address from. If you answer no, you will be prompted with the
following two questions.
–
Enter the IP address for eth0 from the original server:
Answer this question with information provided by your network
administrator.
Enter the netmask for eth0:
Answer this question with information provided by your network
administrator.
Note: After answering these questions for eth0, you are prompted to give the
Note: After answering these questions for eth0, you are prompted to give the
same information for eth1. Answer these questions as outlined above.
Do you want to set a default gateway? (yes/no)
Answer yes if your network has a central server that routes all of the network
traffic. If you answer yes to this question, you are prompted with the next
question.
–
–
Enter the IP address of the default gateway:
Enter the IP address of the central server that routes your network traffic.
Do you want to set a nameserver? (yes/no)
Answer yes if you have a nameserver you would like the USRM server to
use. If you answer yes to this question, you are prompted with the following
question.
–
–
Enter the IP address of the nameserver: