Cisco DNCS System Release 2.7 3.7 4.2
Chapter 1 DST Rules Feature
4
749233 Rev E
Site-Specific Configuration Overview
The way in which you configure the DNCS for DST varies, depending on the version
of system release installed at your site. Review the following information that is
applicable for your currently installed system release and then proceed to the
appropriate chapter for configuration details.
SR 2.7/3.7/4.2 SP0.1 (and Later) Sites
Regional support using the DST GUIIf your DNCS system is running SR
2.7/3.7/4.2 SP0.1 or later, you can configure the DST rules to adjust set-tops for DST
as it is observed in the different regions your network serves. You can also apply the
DST rules to one or more hubs; the set-tops will use the DST rule of the hub to which
they belong.
SR 2.5/3.5/4.0 SP3 and SR 3.4 DNCS Sites
System-wide support using the DST GUIIf your system is running SR
2.5/3.5/4.0 SP3 or SR 3.4, you can configure a DST rule to ensure that the set-tops in
your system adjust to DST on the correct date and at the correct time. The
configuration instructions for your site are similar to those used at SR 2.7/3.7/4.2
SP0.1 sites.