Cisco DNCS System Release 2.7 3.7 4.2 デザインガイド

ページ / 110
4000358 Rev B 
Guidelines for Configuring the DBDS for DOCSIS 
2-7 
CMTS Configuration 
Introduction 
This section provides guidelines for configuring the CMTS to work with DHCTs in 
Mixed DOCSIS/DAVIC mode or DOCSIS mode. 
Interface Configuration 
Either the first (.1) or last usable IP address (.254) from each network block is 
typically configured as the gateway IP address for the end-user devices on each 
cable interface card of a CMTS. In this example, the first usable IP address is 
configured as the gateway IP address. When deploying the DOCSIS-capable DHCTs 
the cable service operator should continue to configure their CMTS as they do today, 
with the following modifications: 
• 
Implement any desired DSG definitions. 
• 
Add a new Gateway IP address (from the DHCT CPE subnet) for the DHCT CPE 
at each CMTS RF interface. 
• 
Add a route pointing to the DNCS so that any packet from the DHCT CPE 
destined to the DNCS is routed appropriately. 
Global Configuration for the DOCSIS Set-top Gateway 
As specified in DOCSIS Set-top Gateway (DSG) Interface Specification, the DSG is 
intended to provide DOCSIS channel transport for out-of-band messaging that is 
traditionally carried on dedicated channels. DSG definitions are established on the 
CMTS to act as gateways for the DHCT broadcast, CA, OOB SI, and Passthru flows 
that must be delivered to the DHCTs in each of the MAC domains of the CMTS.  
The system operator chooses the DSG IP address from the DHCT CPE subnet on 
each CMTS cable interface card that is needed to support DHCT CPEs. The examples 
in this section use the second usable IP address (.2) from the DHCT CPE’s subnet. 
The DNCS delivers the out-of-band data flows to each DSG IP address (taken from 
the DHCT CPE subnet). The DSG definition defined on the CMTS then takes IP 
packets destined for the DSG IP address and encapsulates them in an Ethernet 
frame, using a well-known Cisco MAC address (00:01:A6:D0:0B:1E).   
DHCTs operating in DOCSIS mode can receive DBDS broadcast data without 
establishing an interactive communications path with the CMTS. In this scenario, the 
DBDS supports DOCSIS DHCTs in a one-way operating environment (for example, 
a reverse-path-impaired condition).