Cisco DNCS System Release 2.7 3.7 4.2 ユーザーガイド
Chapter 1 Overview
4
4000820 Rev B
Logo Requirements and Options
This section describes the requirements for MSO and service logos that will be used
with the LogoTool application. It also describes the transparency options that you
can apply to each of your logos.
with the LogoTool application. It also describes the transparency options that you
can apply to each of your logos.
Dimensions
When creating new logos or editing existing logos, you must size them within the
following dimensions:
following dimensions:
Logo Type
Dimensions
(maximum size in pixels)
MSO logos
54 x 47
Service logos
25 x 25
Logo IDs
Although logo IDs are only required for service logos on the DNCS, an ID for both
MSO and service logos is required during the SARA export process. These IDs must
be within the following numeric ranges:
MSO and service logos is required during the SARA export process. These IDs must
be within the following numeric ranges:
Logo Type
ID Range
MSO logos
256 – 32767
Service logos
> 256
Important:
The ID for a service logo should match the ID assigned; make sure that the ID
matches the ID that you defined in the service logo index. Go to Create a Service
Logos Index (on page 21) for details.
Logo IDs must be sequentially numbered.