Cisco DNCS System Release 2.7 3.7 4.2 インストールガイド

ページ / 152
 
Appendix F 
Download LED Indicators 
126 
78-4003052-01 Rev G 
POWER LED Indictors Displayed on DHCTs 
Some DHCTs do not include front-panel alphanumeric LED indicators. These 
DHCTs rely on the flashing POWER LED indicators to give you information about 
their status. 
 
Understanding the POWER LED Indicators 
Blinks Once Every Half-Second 
The POWER LED indicator blinks once every half-second. This is equivalent to the 
h.nnn message LED code that appears on the front panel of alphanumeric LED 
DHCTs. 
An h.nnn condition indicates normal behavior for the DHCT. The condition occurs 
while the DHCT scans the entire frequency spectrum for the presence of a CVT. The 
DHCT is scanning the QAM frequency spectrum for all of your QAMs. 
 
Blinks 2 Times, Pauses, Repeats 
The POWER LED indicator blinks twice, pauses, then repeats. This is equivalent to 
the r.xxx LED code that appears on the front panel of alphanumeric LED DHCTs.  
An r.xxx condition indicates that the DHCT may be downloading software. Do not 
reboot the DHCT. As a CVT download progresses, the hex number decreases 
sequentially to zero, showing the number of blocks remaining. Block size is 
configured on the headend. 
The r.xxx message is normal behavior for the DHCT. Do not reboot the set-top 
unless the message appears constantly. 
To clear the r.xxx message, complete the following steps. 
1  Wait 5 to 20 minutes. The DHCT could be downloading software. 
2  Did this clear the message? 
 
If yes, you have corrected the problem. 
 
If no, follow your company’s escalation procedure.