Cisco DNCS System Release 2.7 3.7 4.2 インストールガイド

ページ / 51
 
78-4011510-01 Rev C 
Install and Configure the Digital System Time Kit to Use the 
2-7 
 
Global Positioning System 
Install the Digital System Time Kit,
 Continued 
Installing the Digital System Time Kit 
Follow these steps to install the Digital System Time Kit. 
1. 
Find a suitable location for the antenna receiver that has a clear view of the 
sky and can be reached from the DNCS with the interface cable. 
2. 
If you are not attaching the antenna receiver to the roof of a building, install a 
sturdy pole that is high enough to have a clear view of the sky. 
3. 
Attach the mounting brackets to the building or to the pole. 
4. 
Attach the threaded conduit pipe to the antenna and the mounting bracket. 
5. 
Route the interface cable between the antenna and the DNCS.  
Note:  The signal plug end of the interface cable connects to the antenna 
receiver. The wire-lead end of the interface cable connects to the terminal 
block on the ADL 1901 converter. 
Establishing GPS to DNCS Connectivity 
Follow these steps to establish connectivity from the GPS to the DNCS. 
Important:  You will have to restart the siManager and qamManager processes on 
the DNCS in order to complete this procedure.  
1. 
Connect the signal plug end of the interface cable into the Acutime-II 
antenna receiver. 
2. 
Before connecting the other end of the interface cable to the ADL 1901 
converter unit, complete these steps: 
a)  Strip the wire bundle sheath to expose about 4 inches of wires. 
b)  Cut the wires that are not going to be used.  
Important:  Refer to Cable Wire Descriptions and Trimming the Cable 
Wires, earlier in this section. 
3. 
Connect the stripped wire ends of the interface cable to the terminal block on 
the ADL 1901 converter unit according to the connection requirements shown 
in the Wiring Diagram for Back Panel of ADL 1901-to-RS232 Converter Unit  
illustration and the Cable Wire Descriptions table, earlier in the section. 
4. 
Is your DNCS an E450, V880, or V890? 
• 
If yes, go to step 5. 
• 
If no, go to step 6. 
5. 
Check the back panel of the DNCS. Is the X985a  DB-25 serial port splitter 
cable connected to the port labeled A/B
• 
If yes, go to step 7. 
• 
If no, connect the serial port splitter cable to the port labeled A/B on the 
back panel of the E450, V880, or V890. Then, go to step 7.