Cisco Cisco 1 GHz GainMaker Amplifier インストールガイド
Installing the Housing
23
Installing the Housing
The following procedures detail how to install the 1.2 GHz GainMaker System
Amplifier housing on a strand (aerial) or in a pedestal.
Amplifier housing on a strand (aerial) or in a pedestal.
To Install the Housing on a Strand (Aerial)
Complete the following steps to install the housing on a strand (aerial). The housing
does not need to be opened for strand installation.
does not need to be opened for strand installation.
Important: The minimum strand diameter should be 5/16 inch.
CAUTION:
Be aware of the size and weight of the housing while strand mounting.
Ensure that the strand can safely support the weight of the housing.
Ensure that the strand can safely support the weight of the housing.
1 Loosen the strand clamp bolts.
2 Lift the housing into proper position on the strand.
3 Slip the strand clamps over the strand and finger-tighten the clamp bolts. This
2 Lift the housing into proper position on the strand.
3 Slip the strand clamps over the strand and finger-tighten the clamp bolts. This
allows additional movement of the housing as needed.
4 Move the housing as needed to install the coaxial cable and connectors. See the
diagrams below for examples.
Signal Flow from Left to Right