Cisco Cisco 870 MHz GainMaker Amplifiers インストールガイド
Chapter 2 Installation and Configuration
28
Installing Accessories
The following section provides instructions for installing accessories into the 1.2
GHz GainMaker Line Extender.
GHz GainMaker Line Extender.
To Install Attenuator Pads
Complete the following steps to install the attenuator pads in the line extender.
Note: For best results, follow this installation procedure exactly.
1 Begin this procedure with the housing open. Refer to To Open the Line Extender
1 Begin this procedure with the housing open. Refer to To Open the Line Extender
Housing (on page 15).
Note: These accessories can be installed without removing the cover.
Note: These accessories can be installed without removing the cover.
2 Install the pad(s) specified by the design print in the appropriate pad slot(s). For
a list of available accessory pad values and part numbers, see datasheet.
Notes:
Be sure that all the pins on the attenuator pad bottom align with the pin holes
in the attenuator pad slot, allowing the attenuator pad to install flat against
the line extender module.
in the attenuator pad slot, allowing the attenuator pad to install flat against
the line extender module.
The locations for attenuator pads are approximately the same for all