Cisco Cisco 1 GHz GainMaker Amplifier インストールガイド
Chapter 2 Installation and Configuration
36
Removing the Line Extender Module from the
Housing
Housing
To Remove the Line Extender Module
Complete the following steps to remove the line extender module.
1 Open the housing. Refer to To Open the Line extender Housing (on page 15).
2 If you are working with an line extender in which AC is present, remove the AC
1 Open the housing. Refer to To Open the Line extender Housing (on page 15).
2 If you are working with an line extender in which AC is present, remove the AC
shunt power directors from the line extender before removing the line extender
module from the housing.
module from the housing.
CAUTION:
RF connectors and housing seizure assemblies can be damaged if AC shunt
power directors are not removed from the line extender before installing or
removing the line extender module from the housing.
power directors are not removed from the line extender before installing or
removing the line extender module from the housing.
3 Unplug the 10-pin keyed connector of the power cable harness from the line
extender module.
4 Remove the power cable harness from the white plastic retainer clips.
5 Unsnap the cable guide from the holes in the line extender module cover.
5 Unsnap the cable guide from the holes in the line extender module cover.
Note: The cable can remain plugged into the power supply module.
6 Using a flat-blade screwdriver, loosen the two module retainer screws.