Cisco Cisco 1 GHz GainMaker Amplifier インストールガイド
12
GainMaker Amplifier Reverse Switch Removal Instruction Sheet
748052 Rev C
System Amplifier Reverse Switch Removal,
Continued
Reconnecting Power to the System Amplifier
These instructions explain how to reconnect the power to a system amplifier located
in the field. If your system amplifier is not located in the field, proceed to Closing
the System Amplifier Housing.
Power direction is set by installing AC shunt power directors for the ports through
Power direction is set by installing AC shunt power directors for the ports through
which AC power should pass.
Note: A red AC shunt power director is included with the system amplifier. This is
Note: A red AC shunt power director is included with the system amplifier. This is
intended to be used to activate the port that supplies power. The red shunt identifies
the shunt to be pulled to remove power for insertion and removal of the amplifier
module.
Follow these steps to reconnect the power to a system amplifier located in the field.
Follow these steps to reconnect the power to a system amplifier located in the field.
1.
Refer to the systems design print to determine AC power routing and reinstall
the proper AC shunt power directors in the required locations.
Result: Power is reconnected to the system amplifier.
2.
Proceed to Closing the System Amplifier Housing.