Cisco Cisco 1 GHz GainMaker Amplifier インストールガイド
748052 Rev C
GainMaker Amplifier Reverse Switch Removal Instruction Sheet
25
Line Extender Reverse Switch Removal,
Continued
Reconnecting Power to the Line Extender
These instructions explain how to reconnect the power to a line extender located in
the field. If your line extender is not located in the field, proceed to Closing the Line
Extender Housing.
Power direction is set by installing AC shunt power directors for the ports through
Power direction is set by installing AC shunt power directors for the ports through
which AC power should pass.
Note: A red AC shunt power director is included with the line extender. This is
Note: A red AC shunt power director is included with the line extender. This is
intended to be used to activate the port that supplies power. The red shunt identifies
the shunt to be pulled to remove power for insertion and removal of the amplifier
module.
Follow these steps to reconnect the power to a line extender located in the field.
Follow these steps to reconnect the power to a line extender located in the field.
1.
Refer to the systems design print to determine AC power routing and reinstall
the proper AC shunt power directors in the required locations.
Result: Power is reconnected to the line extender.
2.
Proceed to Closing the Line Extender Housing.