Cisco Cisco 1 GHz GainMaker Amplifier インストールガイド
2-14
Installing Trim Networks
741338 Rev D
Installing a Trim Network in a DA
Procedure
Follow the procedure to install a trim network in a DA module.
1.
Open the DA housing.
2.
Open the DA module cover.
3.
Switch the ACM/AGC to THERMAL.
4.
Record the RF output levels.
5.
Pull the plug-in jumper from the DA module.
Note: The trim network location is labeled JUMPER OR TRIM PAD on the
Note: The trim network location is labeled JUMPER OR TRIM PAD on the
printed circuit board.