Cisco Cisco OptoStar II 1550nm EDFA インストールガイド
Operating using Console Software
This section introduces the procedures to use the OptoStar II console to manage
the OptoStar II 1550 nm optical amplifier module.
the OptoStar II 1550 nm optical amplifier module.
Before You Begin
•
One PC
•
Mini-USB data cable
•
OptoStar II console software installation package
System Requirements
•
Supported operation system: Windows 7, Windows Vista, Windows Server
2003, and Windows XP
2003, and Windows XP
•
Processor: 400 MHz Pentium or equivalent processor (minimum requirement);
1 GHz Pentium or equivalent processor (recommended)
1 GHz Pentium or equivalent processor (recommended)
•
Memory: 96 MB (minimum requirement); 256 MB (recommended)
•
Hard drive: 500 MB free space required
•
Monitor: 800 x 600, 256-color (minimum requirement); 1024 x 768 high color,
32-bit (recommended)
32-bit (recommended)
Start
1. Make sure that the fibers of the OptoStar II 1550 nm optical amplifier module
are connected.
2. Turn the front panel switch of the OptoStar II power supply module to ON
position. The power supply module and the 1550 nm optical amplifier module
will initialize for about 5 seconds, and the ICIM will load for about 25
seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
will initialize for about 5 seconds, and the ICIM will load for about 25
seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
3. When the device initialization is complete, connect the Mini-USB side of the
USB cable provided with the ICIM to the Mini-USB interface of the ICIM front
panel. The other side of the USB cable should be connected to the USB
interface on the PC. Now the LCD screen shows USB connected, and the
keypads below the LCD screen are temporarily unavailable. The illustration
below shows the connection method.
panel. The other side of the USB cable should be connected to the USB
interface on the PC. Now the LCD screen shows USB connected, and the
keypads below the LCD screen are temporarily unavailable. The illustration
below shows the connection method.
Continued on next page
OL-29666-02
Operation
3-15