Cisco Cisco OptoStar II Driver Amplifier インストールガイド
Operating using ICIM LCD
This section describes how to use the OptoStar II ICIM LCD to operate the
OptoStar II 1550 nm DWDM forward direct modulation transmitter module.
OptoStar II 1550 nm DWDM forward direct modulation transmitter module.
Start
1. Make sure that the fiber and RF cables of the OptoStar II 1550 nm DWDM
forward direct modulation transmitter module are connected.
2. Turn the front panel switch of the OptoStar II power supply module to ON
position. The power supply module and the 1550 nm DWDM forward direct
modulation transmitter module will initialize for about 5 seconds, and the
ICIM will load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
The LCD now displays ICIM loading screen as shown below.
modulation transmitter module will initialize for about 5 seconds, and the
ICIM will load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
The LCD now displays ICIM loading screen as shown below.
3. When the device initialization is complete, remove the ICIM display and
begin operation.
Continued on next page
OL-29668-02
Operation
3-5