Cisco Cisco OptoStar II Driver Amplifier インストールガイド

ページ / 77
Operating using Console Software, Continued 
Setup Parameters 
The table below lists the setup parameters of the  OptoStar II  1550 nm DWDM 
forward direct modulation transmitter module. 
Setup Parameters 
Description 
Factory Default 
Optical Alarm 
Threshold 
Shows/sets optical alarm upper 
limit and lower limit 
Lower limit: 2.2 dB 
lower than standard 
value 
Upper limit: 1.5 dB 
higher than standard 
value 
Gain Control Mode 
Selection 
Shows/sets AGC or MGC gain 
control mode 
AGC mode 
Channel Load 
Shows/sets analog channel 
number, QAM channel number, 
and delta level (dB) 
Analog channel 
number: 30;   
QAM channel 
number: 85; 
Delta level: 6.0 dB 
Laser Status 
Shows/sets laser status: ON/OFF  Laser status: ON 
Alarm ON/OFF 
Shows/sets module alarm status: 
ON/OFF 
Alarm status: ON 
CW/Video Mode 
Selection 
Shows/sets CW/Video mode: 
CW/Video 
Video mode 
Fiber Length 
Sets fiber length 
20 km 1550 nm DMT 
default: 20 km; 
10 km 1550 nm DMT 
default: 10 km 
 
 
Continued on next page 
 
 
OL-29668-02 
   Operation 
3-25