Cisco Cisco OptoStar II Driver Amplifier インストールガイド

ページ / 75
Web Client Software Operation 
This section introduces the procedures to operate the OptoStar II Web Client 
software.   
Before You Begin 
One PC 
Start 
1.   Make sure that the fiber and RF cables of relevant modules of the OptoStar II 
platform have been connected. 
 
2.   Turn the front panel switch of the OptoStar II power supply module to ON 
position. The power supply module and the other modules will initialize for 
about 5 seconds, and the ICIM will load for about 25 seconds. 
Note: The system will achieve optimal working condition after one hour’s 
warm-up. 
3.   When the device initialization is complete, connect to the Ethernet with the 
RJ-45 connector on the rear panel of the ICIM. Connect the PC to the Ethernet. 
The illustration below shows the connection method.   
 
5.   Start the OptoStar II Web Client software. 
 
 
 
Continued on next page 
OL-29664-05 
Operation 
3-45