Cisco Cisco OptoStar II Driver Amplifier インストールガイド

ページ / 67
Important Safety Instructions, Continued 
Equipment Placement 
  WARNING: 
Avoid personal injury and damage to this equipment. An unstable mounting 
surface may cause this equipment failure. 
To protect against equipment damage or injury to personnel, comply with the 
following: 
• 
Install this equipment in a restricted access location. 
 
• 
Do not install near any heat sources such as radiators, heat registers, stoves, or   
other equipment (including amplifiers) that produce heat.   
• 
Place this equipment close enough to a mains AC outlet to accommodate the 
length of this equipment’s power cord. 
 
• 
Route all power cords so that people cannot walk on, place objects on, or lean 
objects against them. This may pinch or damage the power cords. Pay particular 
attention to power cords at plugs, outlets, and the points where the power cords 
exit this equipment.   
• 
Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, 
or sold with this equipment.   
• 
Make sure the mounting surface or rack is stable and can support the size and 
weight of this equipment.   
• 
The mounting surface or rack should be appropriately anchored according to 
manufacturer’s specifications. Ensure this equipment is securely fastened to the 
mounting surface or rack where necessary to protect against damage due to any 
disturbance and subsequent fall.   
Ventilation 
This equipment has openings for ventilation to protect it from overheating. To 
ensure equipment reliability and safe operation, do not block or cover any of the 
ventilation openings. Install the equipment in accordance with the manufacturer’s 
instructions. 
Rack Mounting Safety Precautions 
Mechanical Loading 
Make sure that the rack is placed on a stable surface. If the rack has stabilizing 
devices, install these stabilizing devices before mounting any equipment in the rack. 
  WARNING: 
Avoid personal injury and damage to this equipment. Mounting this equipment 
in the rack should be such that a hazardous condition is not caused due to 
uneven mechanical loading.   
Continued on next page 
viii                                             Safety                                      OL-29667-02