Cisco Cisco OptoStar II 1550nm EDFA インストールガイド
Operating using Console Software, Continued
Setup Parameters
The table below lists the setup parameters of the OptoStar II forward driver
amplifier module.
amplifier module.
Setup Parameters
Description
Factory Default
Input RF Signal
Alarm Threshold
Shows/sets upper limit and
lower limit of the RF input alarm
Lower limit: 10 dBmV
Upper limit: 20 dBmV
Upper limit: 20 dBmV
Output Signal
Slope Settings
Output signal slope settings
(range: 0~9 dB)
0dB
Output Signal Gain
Settings
Output signal gain settings
(range: -9~0 dB)
0dB
Channel Load
Shows/sets analog channel
number, QAM channel number,
and delta level (dB)
PAL D/K system:
Analog channel
Analog channel
number: 59
QAM channel
QAM channel
number: 53
Delta level: 6. 0 dB
Delta level: 6. 0 dB
Alarm ON/OFF
Shows/sets module alarm status:
ON/OFF
Alarm status: ON
3-22
Operation
OL-29667-02