Cisco Cisco OptoStar II 1550nm EDFA インストールガイド
Installing/Removing the Modules
To Install the Module
Connect the ICIM to the rear panel connector of the chassis. Install the module as
shown in the following illustration.
shown in the following illustration.
1. Select Slot 1 (can only be placed in this slot).
2. Inspect all pins on the rear panel and confirm that they are not bent.
3. Hold module vertically with module front towards you.
4. Align the rib on lower side of the module with a guide slot in the chassis and
2. Inspect all pins on the rear panel and confirm that they are not bent.
3. Hold module vertically with module front towards you.
4. Align the rib on lower side of the module with a guide slot in the chassis and
align top rib with matching guide slot in the top of the chassis.
5. Slide module in smoothly until you feel slight resistance, then continue to
push gently until the module connector seats completely.
Note: Check alignment if you feel significant resistance. Do not press hard,
otherwise the connector may be damaged. When installing the module in the
slot, ensure the proper connector alignment.
Note: Check alignment if you feel significant resistance. Do not press hard,
otherwise the connector may be damaged. When installing the module in the
slot, ensure the proper connector alignment.
6. Tighten the mounting screws on the lower front panel of the module by hand
or screwdriver, to secure the module in the chassis.
Note: The torque of mounting screw is 5 - 6 kgf·cm.
Note: The torque of mounting screw is 5 - 6 kgf·cm.
7. Connect Mini-USB cable and RJ-45 cable to monitor the modules with
supporting software.
To Remove the Module
1. Disconnect Mini-USB cable and RJ-45 cable
2. Loosen the mounting screws on lower front panel of the module by hand or
2. Loosen the mounting screws on lower front panel of the module by hand or
screwdriver, to release the module from the chassis.
3. Pull the module slightly to unseat the connector.
4. Hold the module and gently remove it from the chassis
4. Hold the module and gently remove it from the chassis
2-4
Installation
OL-29660-03