Cisco Cisco OptoStar II 1550nm EDFA インストールガイド
Monitoring Interfaces, Continued
Setup Parameters
The table below lists the setup parameters of the OptoStar II 1310 nm forward
transmitter module.
transmitter module.
Setup
Parameters
Description
Factory Default
RF Input Information
Gain Control
Gain Control
Mode Selection
Shows / sets AGC or MGC gain
control mode
AGC mode
RF Attenuator
Shows / sets RF attenuation (dB) (In
AGC mode the field is grayed out; In
MGC mode the function is available:
gain range -5 to +5 dB, with 0.5 dB
step)
0 dB (In AGC mode)
Laser Information
Laser Status
Laser Status
Shows / sets laser status: ON/OFF
Laser status: ON
Comment
Comment
You may add applicable comments as
required.
None
Continued on next page
3-32
Operation
OL-29665-03