Cisco Cisco OptoStar II 1550nm EDFA インストールガイド
Monitoring Interfaces, Continued
The table below lists the basic parameters of the OptoStar II RF switch module.
Basic Parameter
Description
Module Basic Information
Module Node Location
Module Node Location
Shows the node IP where the modules are
located
S/N
Shows module serial number
Slot ID
Shows the slot ID the module is placed
Module Firmware Version
Shows firmware version
Module Temperature
Shows the current module temperature (°C)
RF Input Information
RF Input Status in Channel A/B Shows RF input status in channel A/B
RF Input Status in Channel A/B Shows RF input status in channel A/B
Setup Parameters
The table below lists the setup parameters of the OptoStar II RF switch module.
Setup
Parameters
Description
Factory Default
RF Input Information
Switching Mode
Switching Mode
Selection
Shows/sets Auto/Manual switching
mode
Auto switching
mode
Channel A/B
Selection
Shows/sets channel A/B
Channel A
Comment
Comment
You may add applicable comments as
required.
None
OL-29665-03
Operation
3-47