Cisco Cisco OptoStar II 1550nm EDFA インストールガイド
Connections
RF Cable Connections
Although the modules may be hot-swapped when service must be restored, it is
recommended that the chassis and modules are installed prior to powering up the
chassis.
recommended that the chassis and modules are installed prior to powering up the
chassis.
Use a cable with F-type male RF connector (3/8-32 UNEF thread) to connect the
RF input port A, RF output port B and RF output port on the rear panel of the
module. See the illustration below for RF cable connections.
RF input port A, RF output port B and RF output port on the rear panel of the
module. See the illustration below for RF cable connections.
2-6
Installation
OL-29669-02