Cisco Cisco Web Security Appliance S170 インストールガイド
9
6
Plug In the Appliance
Plug the female end of the power cable into the power supply on
the back panel of the appliance. Plug the male end into an
electrical outlet.
the back panel of the appliance. Plug the male end into an
electrical outlet.
7
Temporarily Change Your IP
Address for Remote Access
To remotely configure the Cisco S190 using the network
connection, you must temporarily change the IP address of your
computer. Alternatively, you can use the serial console to
configure the Cisco S190, without changing the IP address. If
you use the serial console, proceed to section 8 below.
connection, you must temporarily change the IP address of your
computer. Alternatively, you can use the serial console to
configure the Cisco S190, without changing the IP address. If
you use the serial console, proceed to section 8 below.
Note
Make a note of your current IP configuration settings
because you will need to revert to these settings after
you finish the configuration.
because you will need to revert to these settings after
you finish the configuration.
For Windows
Step 1
Connect your laptop to the primary Management Port
(labeled M1) using the cross over or Ethernet cable
included in the system box. The Cisco S190 appliance
uses the M1 Management port only.
(labeled M1) using the cross over or Ethernet cable
included in the system box. The Cisco S190 appliance
uses the M1 Management port only.
Step 2
Go to the Start menu and choose Control Panel.
Step 3
Double-click Network and Sharing Center.
Step 4
Click Local Area Connection and then click Properties.
Step 5
Select Internet Protocol (TCP/IP) and then click
Properties.
Properties.
Step 6
Select Use the Following IP Address.