Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch

Release Notes for Cisco Small Business 200 Series 8-Port Smart Switches Release 1.0.6.2

Release Notes

Limitations and Restrictions

The following caveats are acknowledged in release 1.0.6.2:

Problem:

LLDP-MED (applicable to PoE devices) is not fully operational.

Connected devices only show the Remote ID and Remote Port ID.

Solution:

Use CDP, however, LLDP-MED specific data will not be visible.

Problem:

The configured time settings will not be preserved upon a reboot,

regardless of the method used to set them.

Solution:

Manually reset the time upon reboot.

Problem:

It may take up to 5 minutes for Bonjour to detect the switch after a

reboot.

Solution:

There is no workaround.

The following limitations are carried over from Release
1.0.5.1

Problem:

With a configuring PC attached to port g1, the MAC address binds to

the port. After disconnecting from the switch, the PC can still connect to the switch
and manage the DUT on other ports if using the same MAC address.

Solution:

There is no workaround.

Problem:

When using Internet Explorer version 6 the Filter label is displayed

vertically.

Solution:

Use Internet Explorer version 8 or a different browser.

Problem:

Selected special characters such as: ",',%,!,?,×,÷ are not allowed in any

GUI/CLI user-input fields (e.g. password, vlan name, snmp community fields,
hostname, etc.). In addition, the whitespace/blank is not supported only in the
Password field.

Solution:

It is possible to utilize a subset : ",',%,!,? via CLI configurations, however,

it is recommended that they should not be used due to possible compatibility
issues. If a user had provisioned this subset of characters in previous load via CLI,
such as the password, then the user can continue to access via GUI using these
special characters.