Cisco Cisco Content Security Management Appliance M1070 ユーザーガイド

In this environment, SMA 1 is the primary Security Management appliance that is receiving data from 
ESAs 1-3 and WSA 1. SMA 2 is the backup Security Management appliance receiving backup data from 
SMA1. 

In case of failure, you must configure SMA 2 to be your primary Security Management appliance. 

To configure SMA 2 as your new primary Security Management appliance and restore service: 

Load onto your backup Security Management appliance (SMA2) the configuration file that you saved 
from your primary Security Management appliance (SMA1). 

For information, see 

 or use the 

loadconfig

 command. 

Recreate the IP address from the failed SMA 1 to be the IP address on SMA 2:

On SMA 2 choose Network > IP Interfaces > Add IP Interfaces. 

On the Add IP Interfaces page, enter all of the relevant IP Interface information from the failed 
SMA1 into the text fields to recreate the interface on SMA 2. 

For more information on Adding IP Interfaces, see 

.

Click Submit and Commit.

Enable all of the services on the new Security Management appliance (SMA 2).

In this case, you must re-enable services for ESAs 1-3 and WSA 1. For information, see 

Add all appliances on to the new Security Management appliance (SMA 2).

For information, see 

.

Test to see that each appliance is enabled and working by establishing a connection to the appliances and 
testing the connections.

data