Cisco Cisco OptoStar II 1550nm Transmitter インストールガイド
Connections
Fiber Connections
Although the modules may be hot-swapped when service must be restored, it is
recommended that the chassis and modules are installed prior to powering up the
chassis.
recommended that the chassis and modules are installed prior to powering up the
chassis.
It is also recommended to connect fibers to the front panel before powering up
the system. If fibers must be removed, it is recommended to disconnect power
prior to removal to minimize possible exposure to laser radiation.
the system. If fibers must be removed, it is recommended to disconnect power
prior to removal to minimize possible exposure to laser radiation.
CAUTION:
Use only SC/APC terminated fiber to connect to modules. Clean the
connector using recognized industry practices before connecting to any
module to prevent performance degradation.
connector using recognized industry practices before connecting to any
module to prevent performance degradation.
For fiber cleaning information, see Care and Cleaning of Optical Connectors
(page 2-7).
See the illustration below for fiber connections.
(page 2-7).
See the illustration below for fiber connections.
RF Signal Cable Connections
Use a cable with F-type male RF connector (3/8-32 UNEF thread) to connect the
RF input port on the rear panel of the module. See the illustration below for RF
cable connections.
RF input port on the rear panel of the module. See the illustration below for RF
cable connections.
2-6
Installation
OL-29662-03