Cisco Cisco Email Security Appliance C160 インストールガイド
9
Step 2
Log in with the following credentials:
•
Username: admin
•
Password: ironport
Command-Line Interface
Step 1
Access the command-line interface locally or remotely:
•
To access the CLI locally, set up a terminal to
connect to the serial port using 9600 bits, 8 bits, no
parity, 1 stop bit (9600, 8, N, 1) and flow control
set to Hardware. To physically connect the
terminal, see the
connect to the serial port using 9600 bits, 8 bits, no
parity, 1 stop bit (9600, 8, N, 1) and flow control
set to Hardware. To physically connect the
terminal, see the
•
To access the CLI remotely, initiate an SSH session
to the IP address 192.168.42.42.
to the IP address 192.168.42.42.
Step 2
Log in as admin with the password ironport.
Step 3
At the prompt, run the systemsetup command.
11
Run the System Setup Wizard
The System Setup Wizard starts automatically when you access
the appliance via the web-based interface (or when you run the
systemsetup command from the command-line interface.)
the appliance via the web-based interface (or when you run the
systemsetup command from the command-line interface.)
Step 1
Start the System Setup Wizard.
Step 2
Accept the end user license agreement.
Step 3
Enter information from the
.
Step 4
Set anti-spam and anti-virus security settings.
Step 5
Review the configuration summary page.
Step 6
Click Install this Configuration.