Cisco Cisco FirePOWER Appliance 7020
42-28
FireSIGHT System User Guide
Chapter 42 Enhancing Network Discovery
Working with Application Detectors
Step 1
Select
Policies > Application Detectors
.
The Detectors page appears.
Step 2
Locate the detector you want to activate or deactivate.
If the detector you want to activate or deactivate is not on the first page, you can find it by paging through
the detector list or applying one or more filters. For more information, see
the detector list or applying one or more filters. For more information, see
Step 3
You have the following options:
•
To activate a detector, so that the system will use it when analyzing network traffic, click the
deactivated slider (
deactivated slider (
) next to the detector.
•
To deactivate a detector so that the system will not use it when analyzing network traffic, click the
activated slider (
activated slider (
) next to the detector.
Note that some application detectors are required by other detectors. If you deactivate one of these
detectors, a warning appears to indicate that the detectors that depend on it are also disabled.
detectors, a warning appears to indicate that the detectors that depend on it are also disabled.
Modifying Application Detectors
License:
FireSIGHT
Use the following procedure to modify user-defined application detectors.
To modify an application detector:
Access:
Admin/Discovery Admin
Step 1
Select
Policies > Applications
.
The Detectors page appears.
Step 2
Locate the detector you want to modify.
If the detector you want to modify is not on the first page, you can find it by paging through the detector
list or applying one or more filters. For more information, see
list or applying one or more filters. For more information, see
Step 3
To modify a user-defined detector, click
Edit
next to the detector you want to modify.
The Edit Application Detector page appears.
Step 4
Make changes to the detector.
See
for information on the various
configurations you can change.
Step 5
You have the following options:
•
If you are modifying an inactive user-defined detector, either click
Save
to save your changes, or
click
Save as New
to save the detector as a new, inactive user-defined detector.
•
If you are modifying an active user-defined detector, either click
Save and Reactivate
to save your
changes and immediately start using the modified detector, or click
Save as New
to save the detector
as a new, inactive user-defined detector.