Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch テクニカルリファレンス

Switch Management Access Control

Cisco Small Business 200E Series Advanced Smart Switch Command Reference

73

The management interface is the logical interface used for in-band connectivity 
with the switch via any of the front panel ports. The configuration parameters 
associated with the switch management interface do not affect the configuration 
of the front panel ports through which traffic is switched. The management 
interface is always considered to be up, whether or not any member ports are up; 
therefore, the show network command will always show Interface Status as Up. 

The following shows sample output for the command

(switch) #show network

Interface Status............................... Always Up
IP Address..................................... 10.131.12.78
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.131.12.1
IPv6 Administrative Mode....................... Enabled
IPv6 Prefix is ................................ fe80::205:5ff:fe0a:201/64
Burned In MAC Address.......................... 00:05:05:0A:02:01
Configured IPv4 Protocol....................... DHCP
Configured IPv6 Protocol....................... None
IPv6 AutoConfig Mode........................... Disabled
Management VLAN ID............................. 1

The following commands configure user access to the management interface 
through HTTP.

Use this command to specify the TCP port for use by a web browser to configure 
the switch. To use the default TCP port, use the 

no form of this command.

The HTTP protocol port number.