Brother CM350R 操作ガイド
77
5
c
Pull up the holder to leave the blade in the
rubber area.
rubber area.
■ Installing
a
Grasp the shaft of the new blade, and then
insert it into the blade slot in the end of the
holder.
insert it into the blade slot in the end of the
holder.
The blade shaft is held in place by a magnet in the
holder. Slowly insert the blade shaft, and then slowly
release it after the shaft snaps into place against the
magnet.
holder. Slowly insert the blade shaft, and then slowly
release it after the shaft snaps into place against the
magnet.
b
Twist on the holder cap to attach it to the
holder.
holder.
Fully tighten the cap until the blade extension reaches
its maximum, and then loosen the cap until the blade
is no longer visible.
its maximum, and then loosen the cap until the blade
is no longer visible.
a Tighten the cap until the blade extension
reaches its maximum.
b Loosen the cap until the blade becomes
invisible from the cap end.
Note
• Loosen the holder cap until the blade tip is no
longer visible. The blade extension scale on the
holder applies when the blade begins to be
extended from the cap end. For details on the
blade extension, see “Adjusting the Blade
Extension” on page 24.
holder applies when the blade begins to be
extended from the cap end. For details on the
blade extension, see “Adjusting the Blade
Extension” on page 24.
CAUTION
• After removing the blade holder from the
machine, be sure to retract the blade into the
holder and attach the protective cap.
holder and attach the protective cap.
• Do not leave the blade extended. Otherwise,
injuries may result.
• Please remove protective cap from blade
holder before placing it into the machine
carriage.
carriage.
• Do not allow infants/children to put the
protective caps in their mouths.
b
a