Samsung 460W 5.1Ch Soundbar HW-J470 ユーザーズマニュアル

ENG

CONNECTIONS

●

● Before moving or installing the product, be sure to turn off the power and disconnect the power cord.

●

● If the main unit is powered off, the wireless subwoofer will be in standby mode and the STANDBY LED on

the upper side will come on after the Link indicator (Blue LED) blinks for 30 seconds.

●

● If you use a device that uses the same frequency (2.4GHz/5GHz) as the Soundbar near the Soundbar,

interference may cause some sound interruption.

●

● The maximum transmission distance of the wireless signal between the main unit and the subwoofer and

the main unit and the SWA-7000S is about 10m, but may vary depending on your operating environment.

If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer or the main unit and

the SWA-7000S, the system may not operate at all, because the wireless signal cannot penetrate metal.

●

● If the main unit doesn't make a wireless connection, follow steps 1-5 on the previous page to re-set the

connection between the main unit, the wireless subwoofer, and the SWA-7000S.

●

● A wireless receiving antenna is built into the wireless subwoofer and the SWA-7000S. Keep the both units

away from water and moisture.

●

● For optimal listening performance, make sure that the areas around the wireless subwoofer and

SWA-7000S are clear of any obstructions.

CONNECTING THE SURROUND

SPEAKERS

SURROUND SPEAKERS OUT

SPEAKER IMPEDANCE : 3Ω

ID SET

Surround Speaker (L)

Surround Speaker (R)

Wireless Receiver Module

●

● Place these speakers to the side of your listening position. If there isn't enough room, place these

speakers so they face each other. Position them about 60-90 cm above your ear, facing slightly

downward.

●

● Surround speakers must be connected to the wireless receiver module.

●

● Each speaker has a colored label on its back or underside. Each cable has a single colored band near its

end. Match the band on each cable to the speaker label by color, and then connect the cable to the

speaker.

HW-J470 EN ENG-0311.indd 15

2015/3/24 9:04:32