Samsung SCC-C9302P ユーザーズマニュアル

1. First connect one end of the BNC cable to the VIDEO OUT.

2. Next, connect the other end of the BNC cable to the video input terminal of the 

monitor.

3. Then, plug in the power adapter. Use a “minus” screwdriver to connect one part

of the power adapter consisting of two lines to the power input terminal of the
Camera as follows. (GND: marked with a white line on the cable)

4. Decide on the type of power source you want to use and then adjust the power

selection switch located at the bottom of the power adapter. Then, plug the
power adapter into the power receptacle.

5. If the camera operates normally, the following screen will be displayed for 5 sec-

onds before it disappears.

6. When controlling an RS485, please check the following:

- Communication Speed: 4800 bps ~ 38400 bps
- Data Bit Number: 8 bits
- Stop Bit Number: 1 bit
- Parity Bit: None

SAMSUNG

PROTOCOL

ADDRESS

0

TYPE

RS-485, HALF

BAUD RATE

9600

LENS

OK

ROM VER

1.000

EEP VER

1.000

00578A-SCC-C9302(F)P-E  5/18/06 9:51 AM  Page 24