Samsung SNT-1010P ユーザーズマニュアル
73
Chapter 8 Setting Up
Event Configuration
72
Setting Up
Click the [Close] button.
Clicking the [Apply] button does not close the window.
Event Configuration
(Continued)
To set the motion detection function
<M.D. Function> : <Enable> activates the motion detection function, while <Disable>
disables the function.
<M.D. Configuration> : You can set motion detection performance parameters.
- <Video> : Select a video signal from <Video1> and <Video2> for motion detection.
- <Motion Sensitivity> : Select a motion detection function sensitivity from <High>, <Medium> and <Low>.
The <High> option provides high sensitivity of motion detection and generates motion
detection event if a small motion is detected.
detection event if a small motion is detected.
- <Motion Area> : You can set an area to detect motion.
<Activation Time> : You can set time to accept a motion detection to take an action.
- <Always> : Always conducts the <Action> setting when a motion is detected.
- <Only Scheduled Time> : Conducts the <Action> setting for a motion detection only when it occurs during the
specified time period on the specified day of the week. The Start Time must prior to
and must differ from the End Time.
and must differ from the End Time.
<Action> : You can set an operation to be conducted when a motion is detected.
-
<Alarm Output> : Determines a motion detection output port to which the alarm signal is to be sent.
-
<Output Duration> : Determines the period of time to output the alarm signal to the specified alarm output port
when a motion is detected. If another detection event is generated during the alarm output,
the delay time is recalculated on the basis of the most recently generated motion detection.
the delay time is recalculated on the basis of the most recently generated motion detection.
-
<Alarm Image Transfer> : If <On> is selected, a JPG image is transmitted through FTP or EMail (SMTP)
according to the <EVENT>
<TRANSFER SETUP> settings.
The motion detection function is supported only for <MPEG4> videos.
If both of the <Video1> and <Video2> are set to <MPEG4>, you can select one of them.
If only one of the <Video1> and <Video2> is set to <MPEG4>, the MPEG4 video appears in this field.
Note
To complete the setting, click the
[Apply] button.
[Apply] button.
The settings are saved.
Click <EVENT>
<MOTION
DETECTION>.
The MOTION DETECTION window
appears.
appears.
1
In the MOTION DETECTION window, click the [Motion
Area] button.
The Motion Area window appears.
You can set a specific area to detect a motion in.
2
Click over square boxes corresponding to your desired
motion detection target area.
The selected area is colored in yellow.
3
To cancel a selection, click over the square box once
again.
The square box returns to its original color.
4
To complete the setting, click the [Apply] button.
The settings are saved.
The motions in the selected area will be detected.
To set a motion detection target area
To close the Motion Area window
If the <Video Format> options of the <VIDEO1> and <VIDEO2> are all set to <MPEG4> in <BASIC CONFIGURATION>
<VIDEO>, the image transmission function is not supported.
If the system time is not set in the <SYSTEM>
<DATE/TIME>, the image transmission function is not available.
Notice