Samsung Barre de son de 200 W à 4.1 canaux de série K370 ユーザーズマニュアル

3.  Press the   button on your remote control for 5 seconds while the main unit is turned OFF.
4.  The ID SET message appears on the display of the main unit for a short period of time, and then disappears.
5.  While the subwoofer's and the SWA-8000S's indicators are blinking blue, press the   button on your remote control or 

on the right side of the main unit to turn on the main unit.

6.  The connection is complete if the blue LEDs on the subwoofer and the SWA-8000S stop blinking and glow 

continuously.
•

The main unit, the subwoofer and the SWA-8000S should now be linked (connected).

The LINK indicators (Blue LEDs) on the subwoofer and the SWA-8000S should be glowing continuously and 

not blinking.

If the LINK indicators are not solid blue, the linking process has failed. Turn off the main unit and start again 

from Step 2.

You can enjoy better sound from the wireless subwoofer by selecting a Sound Effect. (See page 10)

  

● Before moving or installing the product, be sure to turn off the power and disconnect the power cord.

● If you use a device that uses the same frequency (2.4GHz) as the Soundbar near the Soundbar, 

interference may cause some sound interruption.

● The maximum transmission distance of the wireless signal between the main unit and subwoofer is about 

32.8 ft, but may vary depending on your operating environment. If a steel-concrete or metallic wall is 

between the main unit and the wireless subwoofer, the system may not operate at all because the wireless 

signal cannot penetrate metal.

● If the main unit doesn't make a wireless connection, repeat steps 1-6 starting on the previous page to 

re-set the connection between the main unit and wireless subwoofer.

  

● The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and 

moisture.

● For optimal listening performance, make sure that the area around the wireless subwoofer location is clear 

of any obstructions.

SURROUND SPEAKERS OUT

SPEAKER IMPED

L

R

Surround Speaker (L)

Surround Speaker (R)

Wireless Receiver Module

  

● Place these speakers to the side of your listening position. If there isn't enough room, place these 

speakers so they face each other. Position them about 2 to 3 feet above your ear, facing slightly 

downward.

  

● Surround speakers must be connected to the wireless receiver module.

● Each speaker has a colored label on its back or underside. Each cable has a single colored band near its end. 

Match the band on each cable to the speaker label by color, and then connect the cable to the speaker.