Samsung HW-H430 ユーザーズマニュアル

●

The Subwoofer's linking ID is preset at the factory and the main unit and subwoofer should link 

(connect wirelessly) automatically when the main unit is turned on. If the link indicator (

) does not 

light when the main unit and subwoofer are turned on, please set the ID by following the procedure 
below.

1.  Plug the power cords of the main unit and subwoofer into an AC wall outlet.

2.  Press the ID SET button on the back of the subwoofer with a small, pointed object for 5 seconds.

• The STANDBY indicator is turned off and the LINK indicator (Blue LED) blinks quickly.

  

 

Before moving or installing the product, be sure to turn off the power and disconnect 
the power cord.

 

If the main unit is powered off, the wireless subwoofer will be in the standby mode and 
the 
STANDBY LED on the upper side will come on after the Link indicator (Blue LED) blinks 
for 30 seconds.

 

If you use a device that uses the same frequency (2.4GHz) near the system, interference 
may cause some sound interruption.

 

The transmission distance of the wireless signal between the main unit and sub is about 
10 m, but may vary depending on your operating environment. If a steel-concrete or 
metallic wall is between the main unit and the wireless subwoofer, the system may not 
operate at all, because the wireless signal cannot penetrate metal.

 

If the main unit doesn't make a wireless connection, follow steps 1-5 above to retry the  
connection between the main unit and wireless subwoofer.

  

 

The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away 
from water and moisture.

 

For optimal listening performance, make sure that the area around the wireless 
subwoofer location is clear of any obstructions.

3.  While the main unit is powered off (STANDBY mode),  

press MUTE button on the remote control for 5 seconds.

4.  The ID SET message appears on the main unit’s VFD display.

5.  To finalize the link, turn the main unit’s power on while the subwoofer’s 

Blue LED blinks.
• The main unit and the subwoofer are now linked (connected).
• The Link indicator (blue LED) on the subwoofer is turned on.
• You can enjoy better sound from the wireless subwoofer by selecting the sound effect. 
• if the link indicator is not solid blue, the linking process has falied, turn off the main unit 

and start again from step 2.

HW-H430 EN-ENG-0813-ECO.indd   11

2015/4/2   8:30:10