Zebra 01407-000 ユーザーズマニュアル
Programming
Software Command Syntax
Software Command Syntax
30
P1003643-001
TTP 1020™/TTP 1030™ Technical Manual
03/03/2009
Software Command Syntax
The commands in this section are grouped after what they do, and these groups are sorted in a
theoretical usage sequence. It starts with commands for specifying the printed page — through
text-and-graphics commands — to cut-and-present commands. System and status commands
are presented at the end.
theoretical usage sequence. It starts with commands for specifying the printed page — through
text-and-graphics commands — to cut-and-present commands. System and status commands
are presented at the end.
Page Setup Commands
Figure 14 • Definition of Page Size
Sets the fixed page length expressed as a number of 0.125-mm pixel line-feeds. Form feed is
effected with the normal cut/eject command RS, or the
effected with the normal cut/eject command RS, or the
FF command.
ESC C
n1 n2
Set fixed page length
1B
43
n1
n2 hex
027
067 n1
n2 decimal
Note •
Use this command when you want a fixed page length, and when you want to print
landscape text and graphics. Shorter tickets will automatically be extended, while longer
tickets will be divided into several tickets of the desired length.
tickets will be divided into several tickets of the desired length.
Note •
Do not use fixed page length less than 75 mm (n1 = 2, n2 = 88).
SW97063-R2
TEXT
T ext
text
Page length
(minimum 75 mm)
(minimum 75 mm)
Page width =
applicable print
window width
applicable print
window width
Paper transport
direction
Distance between cut and print line (17 mm)